Samsung RFG23UERS Manuel D’Utilisation
18_
Setting up
1. Locate the height-adjuster
1
in the freezer
drawer.
Unscrew the four Phillips screws
2
slightly to
loosen the door.
2. Loosen the controller screw
3
with a Phillips
screwdriver.
3. Find the best level to align the door slope.
After adjustment, fi rst tighten screw
3
and then
screw
2
.
CHECKING THE WATER LINE
A water dispenser is one of the helpful features on your
new Samsung Refrigerator. To help promote better
health, the Samsung water fi lter removes unwanted
particles from your water. However, it does not sterilize
or destroy microorganisms. You may need to purchase
a water purifying system to do that. In order for the
new Samsung Refrigerator. To help promote better
health, the Samsung water fi lter removes unwanted
particles from your water. However, it does not sterilize
or destroy microorganisms. You may need to purchase
a water purifying system to do that. In order for the
ice-maker to operate properly, a water pressure of
138~862 kPa is required. Under normal conditions,
a 170 cc (5.75 oz.) cup can be fi lled in 10 seconds. If
the Refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure. Make
sure the water storage tank inside the Refrigerator is
properly fi lled. To do this, press the water dispenser
lever until the water runs from the water outlet.
138~862 kPa is required. Under normal conditions,
a 170 cc (5.75 oz.) cup can be fi lled in 10 seconds. If
the Refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure. Make
sure the water storage tank inside the Refrigerator is
properly fi lled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation kits are available at extra
cost from your dealer. We recommend using a
water supply kit that contains copper tubing.
cost from your dealer. We recommend using a
water supply kit that contains copper tubing.
The new hose-sets supplied with the appliance
are to be used and that old hose-sets should
not be reused.
are to be used and that old hose-sets should
not be reused.
Check the accessory list below.
Connecting to the water supply line
1. First, shut off the main water supply line and turn
the ice-maker off.
2. Locate the nearest cold water drinking line.
3. After connecting the water supply with water fi lter,
3. After connecting the water supply with water fi lter,
turn on water supply and Flush 3 L through fi lter
before use (fl ush approximately 6 minutes).
before use (fl ush approximately 6 minutes).
INSTALLING THE WATER LINE
Connecting the water line to the Refrigerator.
There are several items that you need to purchase to
complete this connection. You may fi nd these items
sold as a kit at your local hardware store.
complete this connection. You may fi nd these items
sold as a kit at your local hardware store.
1
2
Example) The slope is about 2 mm (0.08 inch) as shown
below.
- Rotate the Height Adjuster to -2.0 to reduce the door
slope.
Slope
Reference
plane
3
Water fi lter
Compression fi tting
Compression nut
1
Cold water line
2
Pipe clamp
3
Water line
installation kit
installation kit
4
Shut off valve
DA99-03403B-17.indb 18
DA99-03403B-17.indb 18
2016. 3. 24.
10:02
2016. 3. 24.
10:02