Samsung In-Door Ice Maker Side-By-Side Manuel D’Utilisation

English - 14

Re-attaching the Water Supply Lines

1.  The Water Lines must be fully Inserted into the 

center of the transparent coupler to prevent 
water leakage from the dispenser.

2.  Insert the 2 clips in the install pack as shown 

below, and then confirm that each clip holds 
the line firmly.

Center of Transparent coupler

Clip A (1/4”) 
(6.35 mm)

Make sure the color of the water lines match.

LEVELING THE REFRIGERATOR

Make sure the refrigerator is level so that you can 
make final adjustments. 
Use a level to test if the refrigerator is level both 
side to side and back to front. 
If the refrigerator is not level, you will not be able 
to get the doors perfectly even, which may cause 
moisture condensation and increased energy bills.

The front of the refrigerator is also 
adjustable.

Before levelling the refrigerator, remove 
the front leg cover.

Open both the freezer and refrigerator doors. 
Unscrew the three screws holding the front leg 
cover in place by turning them counter-clockwise. 
When the screws are loose, remove the front leg 
cover.

When the Freezer part is lower than the 
Fridge part.

Insert a flat-blade screwdriver into a slot on the 
Freezer Leg, then turn it clockwise.

When the Fridge part is lower than the 
Freezer part.

Insert a flat-blade screwdriver into a slot on the 
Fridge Leg, then turn it clockwise.

Screw Driver

Leg

Refer to the next section for the best way 
to make very minor adjustments to the 
doors.

DA68-02981B-01.indb   14

2014. 1. 6.   �� 1:50