Alcatel-Lucent OmniAccess 3500 Mode D'Emploi
Chapter
4.
Installation
Chapter 4. Installation
Installing the gateway requires two people. To prevent damage to components from
electrostatic discharge, always follow the proper guidelines for equipment handling
electrostatic discharge, always follow the proper guidelines for equipment handling
and storage.
Caution: In order to reduce the static potential, any person installing, removing, or
handling the gateway should be properly grounded through the use of an approved
antistatic wrist strap.
Caution: In order to reduce the static potential, any person installing, removing, or
handling the gateway should be properly grounded through the use of an approved
antistatic wrist strap.
Items Required
The following items are required at the installation site:
• Phillips screwdriver
• Three Cat6 Ethernet cables (long enough to run between the gateway and the
• Phillips screwdriver
• Three Cat6 Ethernet cables (long enough to run between the gateway and the
target network outlets)
Note: Additional cabling may be required for connectivity through a patch panel.
Note: Additional cabling may be required for connectivity through a patch panel.
• A PC with an Ethernet port and a web browser
• The capability to execute the ktpass command on the Active Directory Server of
• The capability to execute the ktpass command on the Active Directory Server of
the enterprise
• A certificate and associated private key file for the gateway
• A license file for the gateway
• The certificate of the issuing authority for the gateway certificate.
• A license file for the gateway
• The certificate of the issuing authority for the gateway certificate.
Site Preparation
The gateway has the following environmental and airflow requirements:
• The installation site must maintain at any time the operational temperature and
• The installation site must maintain at any time the operational temperature and
the humidity levels listed in the Specification and Compliance Data section of this
document.
• Adequate room for proper air ventilation must be allowed at the front, back, and
sides of the appliance. No clearance is necessary at the top or bottom of the
appliance.
appliance.
The gateway has the following general electrical requirements:
• One grounded electrical outlet must be available for the AC power supply of
• One grounded electrical outlet must be available for the AC power supply of
gateway.
• To connect the gateway to the grounded electrical outlet, use the supplied AC
power cord. Do not use extension cords.
Items Included
Your gateway order includes the following items:
• OmniAccess 3500 NLG Gateway appliance
• OmniAccess 3500 NLG Gateway appliance
7