3R System case k Manuel D’Utilisation

User Manual

Package Contents and Installation of the parts

How to connect cables

POWER LED : Refer to the manual and install it while obeying
the polarities, If a 4-pin connector is supported,
then connect it to the power supply.

HDD LED : Refer to the manual and install it while obeying
the polarities.

POWER SW(Switch) : This switch has no polarity.
It doesn t matter which place you
connect this to the mainboard.

RESET SW(Switch) : This switch has no polarity.
It doesn t matter which place you
connect this to the mainboard.

RESET SW

POWER SW

H.D.D LED

USBUSB

AUDIOAUDIO

POWER LED

* In case of LED connector, the terminal with the ▲ mark is + .

USB AUDIO

Paper Washer ‒ Use this with 3.5 screws and mainboard supporter
for electrical insulation.

Screw 3 - Use this to secure CD-ROM, FDD and various PCI slot
cards.

Screw 3.5 - Use this to secure Mainboard and PSU.

Series

PC Speaker - This is installed in mainboard and calls
the condition of the system.

Mainboard supporter - Use this only where required, and assemble
using Paper Washer(Red Washer).

Screw(HDD) - Use this to secure HDD.

: Connect it to the terminals on the Mainboard.

▶

Speciﬁcations and improvements in the design of our PC case are subject

to change without any prior notice.
▶

*Warranty voids when damage is caused by user s abuse, misuse or

       by a natural disaster.
     *Warranty voids when damage is caused by modifying the product or
       by using the product in improper application.
▶

For the detailed A/S and support, please visit our website.

(http://www.3rsys.com)

TEL : 82 2 2027 2555 Fax : 82 2 2027 2088 e-mail : support@3rsys.com

메인보드

* How to assemble the Screw: Be sure to
   install the paper washer between
   the Mainboard and the Screw(3.5  )
   to prevent a short circuit.