3R System case k Manuel D’Utilisation
Functions
* 1-channel temperature monitor
* 1-channel fan speed control
* Auto fan speed control
▶ 40℃ : Low
50℃ : Mid
60℃ : High
* Immediate visual indication of Fan/HDD operation
* On-board Power & Reset Switch
* 1-channel temperature monitor
* 1-channel fan speed control
* Auto fan speed control
▶ 40℃ : Low
50℃ : Mid
60℃ : High
* Immediate visual indication of Fan/HDD operation
* On-board Power & Reset Switch
Buttons
* LCD RESET : Resets to default settings
* LCD SELECT : Switches fan speed from Low to Mid to High
* POWER SW : System Power Switch
* RESET SW : System Reset Switch
* LCD RESET : Resets to default settings
* LCD SELECT : Switches fan speed from Low to Mid to High
* POWER SW : System Power Switch
* RESET SW : System Reset Switch
Functions
* 1-channel temperature monitor
* 2-channel fan speed control
* 6-level fan speed control (manual)
* Fan speed storage function
* Auto fan speed control
▶ 40℃ : Low
50℃ : Mid
60℃ : High
* Immediate visual indication of Fan/HDD operation
* Displays system running time
* 1-channel temperature monitor
* 2-channel fan speed control
* 6-level fan speed control (manual)
* Fan speed storage function
* Auto fan speed control
▶ 40℃ : Low
50℃ : Mid
60℃ : High
* Immediate visual indication of Fan/HDD operation
* Displays system running time
Buttons
* LCD RESET : Resets to default settings
* MODE : Switches fan control channels
* UP : Increases fan speed (level 1 → level 6 → Auto)
* DOWN : Decreases fan speed (level 6 → level 1 → Auto)
* LCD RESET : Resets to default settings
* MODE : Switches fan control channels
* UP : Increases fan speed (level 1 → level 6 → Auto)
* DOWN : Decreases fan speed (level 6 → level 1 → Auto)
Thermal Probe : Place this sensor to the proper place to
measure the temperature inside the case.
measure the temperature inside the case.
Fan Power Connector : Connect this to the 3-pin Fan
provided in the case.
(Only available for the LCD product)
provided in the case.
(Only available for the LCD product)
RESET
LCD RESET
MODE
UP
DOWN
LCD SELECT
POWER
RESET
How to connect cables
How to connect cables
4-pin Power Supply Connector : Connect this to PSU.
(Only available for the LCD product)
(Only available for the LCD product)
* Do not place the sensor on CPU core, or Heatsink.
* If there is the gap between cooler base and CPU
core because of the wire of the sensor, CPU may
be damaged.
* If there is cooler guide, the cable of the sensor
should be replaced under the cooler guide to
avoid the disconnection.
* If there is the gap between cooler base and CPU
core because of the wire of the sensor, CPU may
be damaged.
* If there is cooler guide, the cable of the sensor
should be replaced under the cooler guide to
avoid the disconnection.