3com WX1200 3CRWX120695A Manuel D’Utilisation

For example, the following command sets the current WX switch as a 
peer of the Network Domain seed with IP address 192.168.9.254:

WX1200# set network-domain peer 192.168.9.254
success: change accepted.

This command is valid on Network Domain seeds only.

In a Network Domain, at least one seed device must be aware of each 
member device. The seed maintains an active TCP connection with the 
member. To configure a WX switch as a member of a Network Domain, 
you specify one or more Network Domain seeds for it to use. 

If you specify multiple Network Domain seeds, you can also specify the 
affinity the WX switch has for each seed. The Network Domain member 
initially attempts to connect to the seed with which it has the highest 
affinity. If that seed is unavailable, then the WX switch attempts to 
connect to the seed with which it has the next-highest affinity. If the 
member connects to a seed with which it does not have the highest 
configured affinity, then it periodically attempts to connect to its 
highest-affinity seed. When the WX switch reconnects to the 
highest-affinity seed, its communication with the next-highest-affinity 
seed stops.

Use the following command to set the current WX switch as a member of 
a Network Domain where a specified WX switch is a seed:

set network-domain mode member seed-ip ip-addr [affinity num]

You can enter this command multiple times on a WX switch, specifying 
different Network Domain seeds with different affinity values. The affinity 
value can range from 1 – 10, with 10 being the highest affinity. The 
default affinity value is 5.

For example, the following command sets the current WX switch as a 
member of a Network Domain where the WX switch with IP address 
192.168.9.254 is a seed:

WX1200# set network-domain mode member seed-ip 192.168.9.254
success: change accepted.