ADC CRA-C Manuel D’Utilisation
![ADC](https://files.manualsbrain.com/attachments/8cc03e7ad104bd9ecb6517f897298e2bcff16a24/common/fit/150/50/fe0e0e6509736c6d48ca34500339ed8129758ff172d818b1bfcb71e87b70/brand_logo.jpeg)
Megabit Modem CRA-C User Manual
17
CONFIGURE AND VIEW STATUS
In this chapter, you configure the Megabit Modem CRA-C or view system
status using an ASCII terminal connected to the console port. Go to
the following sections:
status using an ASCII terminal connected to the console port. Go to
the following sections:
To complete this task
Go to page
Connect to an ASCII terminal
17
How to log on and navigate the menus
19
How to configure a remote unit
23
Configure the system settings
24
Configure the ADSL transceiver
26
Configure the Bridge/Router
30
View status
41
Log out
49
Connect to an ASCII Terminal
Connect the Megabit Modem CRA-C to an ASCII terminal:
1
Plug the console adapter into the standard 9-pin COM port on
the ASCII terminal and tighten the captive screws until they are
snug (Figure 7). (Skip this step if the ASCII terminal has an
RJ-48 jack.)
the ASCII terminal and tighten the captive screws until they are
snug (Figure 7). (Skip this step if the ASCII terminal has an
RJ-48 jack.)
2
Connect one end of the silver console cable to the
console adapter.
console adapter.
3
Connect the other end of the silver console cable to the console
port on the Megabit Modem CRA-C rear panel.
port on the Megabit Modem CRA-C rear panel.