HP designjet l65500 Manuel
Message
Recommendation
Lower lever
Lower the substrate pressure handles. See the User's guide.
Maintenance #N advised. Please contact HP
You are advised to contact your service representative. See
.
No substrate loaded
Load substrate.
Out of cleaner roll
Replace the printhead cleaning roll. See
.
Printer cannot carry on printing
Check that tri-phase power supply is working and the ambient
temperature is within the normal range. This problem can also
be caused by holes in the substrate, by reflective or
transparent substrates or by a dirty or faulty temperature
sensor.
temperature is within the normal range. This problem can also
be caused by holes in the substrate, by reflective or
transparent substrates or by a dirty or faulty temperature
sensor.
Printer cannot cool down
If the ambient temperature is within the normal range, this
problem may be caused by removing the substrate too quickly
after printing. Try leaving the substrate in the printer until
temperatures settle down after printing.
problem may be caused by removing the substrate too quickly
after printing. Try leaving the substrate in the printer until
temperatures settle down after printing.
Printer cannot warm up
Check that the tri-phase power supply is working. This problem
can also be caused by holes in the substrate, by reflective or
transparent substrates or by a dirty or faulty temperature
sensor.
can also be caused by holes in the substrate, by reflective or
transparent substrates or by a dirty or faulty temperature
sensor.
Printer waiting for rearm. Press the power button
Press the
Power Enable
button on the lower left of the printer.
See the User's guide.
Remove {color} printhead
Remove the printhead. See the User's guide.
Replace {color} cartridge
.
Replace {color} printhead
Replace the printhead. See
Replace aerosol filter
You are advised to replace both aerosol filters. See
.
Reseat {color} cartridge
Reseat the ink cartridge. See
.
Reseat {color} printhead
Reseat the printhead. See
Select substrate name in the IPS
Select the name of the loaded substrate in the HP Internal Print
Server.
Server.
Subs. advance cannot be tracked automatically
The substrate-advance sensor cannot track the substrate, and
should be turned off. See
should be turned off. See
Substrate jam: remove substrate
See
Very low cleaner roll
Be ready to replace the printhead cleaning roll very soon.
Table 10-2
Numerical error codes
Error code
Recommendation
14.2
Tri-phase power is unexpectedly off. Call your service representative, and be prepared to
answer questions about indicator lights and fuses. See
answer questions about indicator lights and fuses. See
14.3
The tri-phase voltage is not set. Set it using the front panel.
14.5:12
Restart the printer.
Table 10-1
Text messages (continued)
ENWW
45
Fron
t-panel
e
rrors