HP designjet l65500 Manual

Lower lever

Lower the substrate pressure handles. See the User's guide.

Maintenance #N advised. Please contact HP

You are advised to contact your service representative. See

.

No substrate loaded

Load substrate.

Out of cleaner roll

Replace the printhead cleaning roll. See 

.

Printer cannot carry on printing

Check that tri-phase power supply is working and the ambient
temperature is within the normal range. This problem can also
be caused by holes in the substrate, by reflective or
transparent substrates or by a dirty or faulty temperature
sensor.

Printer cannot cool down

If the ambient temperature is within the normal range, this
problem may be caused by removing the substrate too quickly
after printing. Try leaving the substrate in the printer until
temperatures settle down after printing.

Printer cannot warm up

Check that the tri-phase power supply is working. This problem
can also be caused by holes in the substrate, by reflective or
transparent substrates or by a dirty or faulty temperature
sensor.

Printer waiting for rearm. Press the power button

Press the 

Power Enable

 button on the lower left of the printer.

See the User's guide.

Remove {color} printhead

Remove the printhead. See the User's guide.

Replace {color} cartridge

Replace the ink cartridge. See 

.

Replace {color} printhead

Replace the printhead. See 

Replace aerosol filter

You are advised to replace both aerosol filters. See 

.

Reseat {color} cartridge

Reseat the ink cartridge. See 

.

Reseat {color} printhead

Reseat the printhead. See 

Select substrate name in the IPS

Select the name of the loaded substrate in the HP Internal Print
Server.

Subs. advance cannot be tracked automatically

The substrate-advance sensor cannot track the substrate, and
should be turned off. See 

Substrate jam: remove substrate

See 

Very low cleaner roll

Be ready to replace the printhead cleaning roll very soon.

14.2

Tri-phase power is unexpectedly off. Call your service representative, and be prepared to
answer questions about indicator lights and fuses. See 

14.3

The tri-phase voltage is not set. Set it using the front panel.

14.5:12

Restart the printer.

ENWW

45