HP laserjet 3390, 3392 all-in-one Instruction De Maintenance
Fuser
Several parts must be removed before you can remove the fuser. Removal procedures for the following
parts are included in this section about removing the fuser:
parts are included in this section about removing the fuser:
●
Fan
●
Duplex-drive gears
●
Duplex solenoid
Fan
1.
Remove the following components.
●
Right cover. See
●
Left cover. See
.
●
Rear cover. See
.
●
Top cover. See
.
●
Convenience-stapler power supply. See
.
●
Convenience-stapler power supply bracket. See
2.
Disconnect one connector (callout 1) at the ECU and feed the wire-harness through the hole in the
chassis (behind the power-switch PCA).
chassis (behind the power-switch PCA).
NOTE
It might be easier to remove the wire-harness if you remove the power-switch PCA
.
1
Figure 5-54
Remove the fan (1 of 2)
152
Chapter 5 Removal and replacement
ENWW