Sony CMT-DH7BT Manuel D’Utilisation
CMT-DH7BT.GB.3-097-195-11(2)
GB
Bluet
ooth D
evic
e
e
Continued
Pairing this system with a Bluetooth
device
Pairing is an operation where Bluetooth
devices register with each other
beforehand. Use the procedure below
to pair the system with your Bluetooth
device. Once a pairing operation is
performed, it does not need to be
performed again. If pairing is already
completed, proceed to “Playing music of
a Bluetooth device” (page 54).
1
Place the Bluetooth device to be
connected to this system within
1 meter of the system.
connected to this system within
1 meter of the system.
2
Select the Bluetooth function.
Press FUNCTION +/
repeatedly
to select “BLUETOOTH” (or press
BLUETOOTH
on the unit).
3
Operate the Bluetooth device
and perform the pairing
operation.
and perform the pairing
operation.
For details about the operations of
the Bluetooth device, refer to the
operation manual supplied with your
Bluetooth device.
When searching for this system
When searching for this system
with the Bluetooth device, a list of
the devices found may appear in the
Bluetooth device display depending
on the type of Bluetooth device.
This system appears as
“CMT-DH7BT.”
When establishing a connection with
When establishing a connection with
this system, select the audio profile
(A2DP, AVRCP) at the Bluetooth
device. If the Bluetooth device does
not support the AVRCP profile, you
cannot perform playback or other
operations with the system (page 54).
4
Enter the passcode.
Passcode entry may be required
depending on the type of Bluetooth
device.
When “PIN?” and a countdown
When “PIN?” and a countdown
appear, enter the passcode at the
system as follows:
Press the numeric buttons
(or
+/
and /
) to
enter the same passcode that was
entered at the Bluetooth device,
and then press ENTER
(or
BLUETOOTH OPR
on the unit).
Once pairing is completed and the
connection is established, the system
display changes as follows:
“Connect” Name of the Bluetooth
device
To cancel passcode entry partway
Press
.
Notes
“Passcode” may be called “Passkey,” “PIN
code,” “PIN number” or “Password,” etc.
depending on the device.
This system only supports numerical
passcodes up to 4 digits.
The pairing standby status of the system is
cancelled after about 30 seconds. If pairing is
not successful, redo the procedure from step
1.
While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.