Toshiba brst-10 Manuel D’Utilisation
EO1-13013
3-2
5
5
5
5
5
POWER Switch
When turned on, the Power LED goes on and the printer is ready to print.
When turned off, the head unit/ ink cartridge is moved to the cleaning position and is capped. The
POWER LED is turned off.
If turned off during printing, the print data is lost.
At the moment the power is supplied from the external power supply unit, the printer is in the condition
of Power off (LED not lit) until the power switch is pressed.
When the first time the power is turned on with the external power supply unit, the initial operation is
performed.
When turned on, the Power LED goes on and the printer is ready to print.
When turned off, the head unit/ ink cartridge is moved to the cleaning position and is capped. The
POWER LED is turned off.
If turned off during printing, the print data is lost.
At the moment the power is supplied from the external power supply unit, the printer is in the condition
of Power off (LED not lit) until the power switch is pressed.
When the first time the power is turned on with the external power supply unit, the initial operation is
performed.
6
6
6
6
6
RESET Switch
If you press and hold this switch for a few seconds, the initial operation is performed.
NOTE: Clean the head unit only when it becomes dirty or a dot missing occurs. Unnecessary
If you press and hold this switch for a few seconds, the initial operation is performed.
NOTE: Clean the head unit only when it becomes dirty or a dot missing occurs. Unnecessary
cleaning will waste ink.
7
7
7
7
7
FEED Switch
Used for feeding the receipt and the slip.
If there is a slip, the slip is fed.
If not, the receipt paper is fed.
Used for feeding the receipt and the slip.
If there is a slip, the slip is fed.
If not, the receipt paper is fed.
8
8
8
8
8
CARTRIDGE Switch
Used for changing the ink cartridge or the head unit/ ink cartridge.
When the switch is pressed with the printer cover removed, the carriage is moved to the head unit/ ink
cartridge replacement position.
Press this switch again after changing the ink cartridge or the head unit/ ink cartridge, and the carriage
is moved to home position and the initial operation is performed.
Used for changing the ink cartridge or the head unit/ ink cartridge.
When the switch is pressed with the printer cover removed, the carriage is moved to the head unit/ ink
cartridge replacement position.
Press this switch again after changing the ink cartridge or the head unit/ ink cartridge, and the carriage
is moved to home position and the initial operation is performed.
3.2 OPERATION PANEL
3. OVERVIEW
POWER
FEED
RESET
CART-
RIDGE
SLIP
INKOUT
POWER
ERROR
1
2
5
6
3
4
7
8
1
1
1
1
1
POWER LED (Green)
On:
On:
Power is supplied.
Off:
Power is not supplied.
Blinking: Ink is being initial operation when
the power turns ON.
2
2
2
2
2
SLIP LED (Green)
On:
On:
Slip mode
Off:
Receipt mode
Blinking: Slip insertion wait state
3
3
3
3
3
INKOUT LED (Orange)
On:
On:
Ink-end detected
Off:
Ink-end not detected (normal
status)
status)
Blinking: Ink-near-end detected
4
4
4
4
4
ERROR LED (Red)
On:
On:
Paper jam error detected or
Cover open error detected or
Cutter error detected.
Cover open error detected or
Cutter error detected.
Off:
Error not detected (normal status)
Blinking: Receipt paper end detected
Fig. 3-3