Toshiba brst-10 Manuel D’Utilisation

5-1

EO1-13013

5.1 CONNECTING THE POWER CORD AND CABLES

Fig. 5-1

Serial Interface Cable
(RS-232C)

to Host

to EPSON Drawer

to AC Adapter

Drawer interface Cable

DC Power Cable

* EPSON is a trademark of SEIKO EPSON CORPORATION.

NOTE: Please use the TEC PS-10-QM AC adapter.  To purchase it, please contact your nearest

TOSHIBA TEC service representative.

1. Connect the serial interface cable (corresponding to inch screws) to the printer.
2. If the EPSON* drawer is connected, connect the drawer interface cable.
3. Connect the power cord so that the D cut section faces up.
4. Plug in the AC adapter.  The printer performs initial operation.

POWER

POWER

SWITCH

: Not depressed.

: Depressed.

LED

: LED off

: LED on

: LED blinking

1. Before connecting the power cord and cables to the printer, turn the power of the ECR or POS

terminal OFF.

2. To avoid injury and printer damage, be careful not to catch your fingers or any objects while the

carriage moves right and left in the initial performance.

3. Please be careful when handling ink cartridges, not to get ink on your hands or in your eyes.

If you accidently get ink on your hands wash them with soap and water.  If any ink should get
into your eyes immediately flush them out with clear water.

4. Never touch the metal portion of the head unit/ ink cartridge.  Doing so will injure your fingers.

1. Do not put anything on the printer cover and never press on it.
2. Use only TOSHIBA TEC specified paper.  Use of non-specified paper may lower the print

quality or shorten the cutter life.

3. Set the receipt roll in the correct direction.  Failure to do this may cause a paper jam error.
4. Do not drop or shake the head unit/ ink cartridge.  Doing so may cause ink to spill over.  Once

ink gets on your clothes, it cannot be removed.