Toshiba brst-10 Manuel D’Utilisation
5-4
5. INSTALLATION PROCEDURE
EO1-13013
1. Open the paper cover toward the rear
1
.
2. Cut off both adhesive areas of a new receipt roll.
NOTE:
Do not insert the receipt paper with adhesive portions into the printer. If so, adhesive will
attach to the feed roller. This may cause a slant print or a paper jam.
attach to the feed roller. This may cause a slant print or a paper jam.
5.3 LOADING THE RECEIPT ROLL
Adhesive
Adhesive
Fig. 5-7
POWER
FEED
RESET
CART-
RIDGE
SLIP
INKOUT
POWER
ERROR
6. Depress the [CARTRIDGE] switch.
The printer performs the initial operation. After the initial
operation is finished, the carriage returns to the home
position (right end).
operation is finished, the carriage returns to the home
position (right end).
Fig. 5-6
Printer Cover
Hooks
Top Cover
7. Insert the two hooks into the holes on the top cover, and then close the printer cover slowly.