Toshiba strata ip5000 Manuel D’Utilisation

You can transfer a call to a busy station from either a DSS console or an ADM. Use 
the DSS to transfer the call, even though the DSS LED associated with the station you 
are “transferring to” is red.

1. Press DSS corresponding to the busy station to be called.

You may hear a busy tone. The original caller is placed automatically on hold. The 
Line or extension LED flashes green at double the on-hold rate, and the DSS LED 
remains steady red.

2. Hang up.

The call rings the called station once with the camp-on tone. While the called 
station is receiving this tone, the Line LED flashes green (on-hold rate) or if you 
are on a extension button, it goes idle. The [DSS] LED remains steady red.

When the called station answers the transferred call, the Line LED becomes steady 
red. The [DSS] LED remains steady red. 

If the busy station is in the Do Not Disturb mode, the call will not transfer, but 
will recall your telephone immediately.

If the call is not answered after a specified Recall time set in system programming, 
camp-on is cancelled and the transferred call rings back.

If your ADM or DSS console is equipped with a 

Line

 button, you can answer outside 

line calls from the ADM or DSS console as you would from a digital telephone.

To answer an incoming outside line call to a ADM or DSS Console, press the 
flashing 

Line

.

Your ADM or DSS console may be equipped with 

SD

 (Speed Dial) buttons that can 

be programmed to dial telephone numbers or to access features. 

SD

 buttons on either 

the ADM or DSS console function like 

SD

 buttons on digital telephones.