Toshiba 3 lcd data tlp680u Manuel D’Utilisation

The image is automatically adjusted.
For further adjustments, follow the below
steps.

To select another item, go back to step 5.

Phase:

To reduce flickers.

H-position: To shift the image to the

left (–), to the right (+).

V-position:

To shift the image down (–),
to up (+).

Clock

To remove vertical stripes.

The menu disappears.

Preparation
• Display the image as explained in “Picture

Projection”. 

• Set the POINTER/PJ selector to “PJ”.

• When performing the automatic projection

adjustment, use a bright and distinctly edged
picture.

• Pressing AUTO SET on the remote control

can also adjust the image automatically. 

• If you project an image from a computer with

an LCD screen while monitoring the image on
the computer, the image may not be projected
properly, depending on the computer model.
In this case, turn off the computer display, or
make the necessary picture adjustments on
the projector. For details on controlling the
computer display, etc., refer to the computer’s
manual and description on the software for
the computer used.

• During adjustments of “H-position” or “V-

position”, the image may not be projected
properly.

• While using, an aberration of the phase may

occur. In that case, adjust “Phase” again.

• Some item may be displayed in gray

depending on an input source. The item
displayed in gray cannot be adjusted and/or
set.

• These adjustments are stored until you turn

the power off.

• To store the adjustments even if the power is

turned off, follow the procedure of “Saving
data”. 

• Pressing RESET will return the adjustment or

setting currently selected to default.

RESET

AUTO SET

A u t o s y n

I ma g e

c .

P h a s e

–

+

H – p o s i t i o n

V – p o s i t i o n

C l o c k

–

+

–

+

–

+