kymco mo movie125150 Instruction De Maintenance

. LIGHTS/INSTRUMENTS/SWITCHES

17-1

SERVICE INFORMATION

GENERAL INSTRUCTIONS
• An electric tester is needed to measure or test the electric equipment.
• Be sure to use fuses and bulbs of the same specifications to avoid damage of electrical equipment.
• After installation of each switch, a continuity check must be performed. A continuity check can

usually be made without removing the part from the motorcycle.

TROUBLESHOOTING

Lights do not come on and horn does not

Engine starts but stalls during idling

sound when ignition switch is “ON”

•Faulty auto bystarter

• Faulty ignition switch

• Faulty auto bystarter resistor

• Fuse burned out

• Poorly connected or broken wire

• Weak battery

• Clogged carburetor

• Burned bulb
• Faulty switch
• Faulty horn
• Poorly connected, broken or shorted wire

Fuel gauge pointer does not register

Fuel gauge pointer does not move

correctly

• Faulty fuel gauge

• Faulty fuel unit

• Poorly connected, broken or shorted wire

• Faulty fuel unit float

ELECTRICAL EQUIPMENT LAYOUT......17-0 HANDLEBAR SWITCHES....................17-3

SERVICE INFORMATION......................17-1 STOP SWITCHES...................................17-5

TROUBLESHOOTING.............................17-1 HORN......................................................17-5

HEADLIGHT.............................................17-2 FUEL GAUGE ........................................17-5

FRONT TURN SIGNAL LIGHT .............17-2 FUEL UNIT.............................................17-6

POSITION/REAR TURN SIGNAL LIGHT...17-2 AUTO BYSTARTER..............................17-6

IGNITION SWITCH .................................17-3 INSTRUMENTS.....................................17-8