kymco mo movie125150 Instruction De Maintenance

Remove the battery cover screws on the floor

board.

Open the battery cover and remove the

battery by removing the bolt and band.

First disconnect the battery negative (-) cable

and then the positive (+) cable.

The installation sequence is the reverse of

removal.

BATTERY VOLTAGE (OPEN CIRCUIT

VOLTAGE) INSPECTION
Remove the floor board.

Open the battery cover and disconnect the

battery cables.

Measure the voltage between the battery

terminals.
Fully charged : 13.1V

Undercharged : 12.3V max.

CHARGING
Connect the charger positive (+) cable to the

battery positive (+) terminal.

Connect the charger negative (-) cable to the

battery negative (-) terminal.

Charging current : Standard : 0.7A

Quick

: 3.0A

Charging time

: Standard : 5_

10 hours

Quick

: 30 minutes

After charging: Open circuit voltage: 12.8V min.

Battery Cover Screw

When disconnecting the battery positive

(+) cable, do not touch the frame with

tool; otherwise it will cause short circuit

and sparks to fire the fuel.

•

Keep flames and sparks away

from a charging battery.

•

Turn power ON/OFF at the

charger, not at the battery terminals to

prevent sparks near the battery to avoid

explosion.

•

Charge the battery according

 

to

the current specified on the battery.

• Quick charging should only be done in

an emergency.

• Measure the voltage 30 minutes after

the battery is charged.

＊

Battery charging inspection must be

performed with a voltmeter.

＊

First connect the positive (+) cable and then

negative (-) cable to avoid short circuit.

Battery  Band

＊

＊

＊