Yamaha SPX2000 Manuel D’Utilisation
10
SPX2000—Owner’s Manual
Operation
Basic operation
This section provides a simple explanation of how to input signals to the SPX2000,
apply effects, and output the result. The overall steps are as follows.
apply effects, and output the result. The overall steps are as follows.
Make connections to external devices
↓
Turn the power on
↓
Select the input signal
↓
Select an effect
↓
Recall the effect
↓
Switch the effect on/off
The connectors you use will depend on whether the input/
output signals are analog or digital.
output signals are analog or digital.
• Analog input:
Connect your device to the [INPUT] jacks ([).
• Digital input:
Connect your device to the [AES/EBU IN] jack (X).
• Analog output:
Connect your device to the [OUTPUT] jacks (Y).
• Digital output:
Connect your device to the [AES/EBU OUT] jack (W).
Related items
• Selecting the word clock source......................... page 18
• Using your computer to
control the SPX2000 ............................................ page 6
• Using MIDI messages to
control the SPX2000 ......................................... page 88
Here’s how to turn on the power of a system that includes
the SPX2000.
the SPX2000.
1
Protect your monitor system
Before you turn on the power of the SPX2000, turn off
the power of the device that is connected to the [OUT-
PUT] jacks (Y) or [AES/EBU OUT] jack (W). Also
turn the [INPUT L
Before you turn on the power of the SPX2000, turn off
the power of the device that is connected to the [OUT-
PUT] jacks (Y) or [AES/EBU OUT] jack (W). Also
turn the [INPUT L
R] control (1) to minimize the
L/R input signal level (the inner knob controls the L
channel, and the outer knob controls the R channel).
channel, and the outer knob controls the R channel).
2
Turn on the power of the SPX2000
Press the [POWER ON/OFF] button (P) to turn the
power on.
Press the [POWER ON/OFF] button (P) to turn the
power on.
→ The front panel display and LEDs will light.
3
Turn on your external devices
Turn on the power of devices connected to the
SPX2000.
Turn on the power of devices connected to the
SPX2000.
Make connections to external
devices
devices
NOTE: If you are inputting/outputting analog signals, you must
set the [INPUT –10 dBu/+4 dBu] switch (
set the [INPUT –10 dBu/+4 dBu] switch (
\
) and the [OUTPUT
–10dBu/+4dBu] switch (
Z
) appropriately for the signal level of
the connected devices.
You must turn off the power of all devices before you
make connections.
make connections.
Turn the power on
NOTE:To prevent high-volume noise from being out-
put from your speakers, turn on the power starting
with the device that is closest to the audio source.
put from your speakers, turn on the power starting
with the device that is closest to the audio source.
Example: sound modules → mixer → SPX2000 →
power amp
power amp
Reverse this order when turning the power off.