Escalade Sports 2l-6740-00 Manuel D’Utilisation
THE DRAWINGS IN THIS
MANUAL HAVE BEEN
EXAGGERATED OR MODI
TO SHOW DETAILS.
MANUAL HAVE BEEN
EXAGGERATED OR MODI
TO SHOW DETAILS.
IMPORTANT! READ THIS
MANUAL ALL THE WAY
THROUGH BEFORE BEGINNING
TO PUT YOUR POOL TABLE TO-
GETHER! THEN READ EACH
STEP COMPLETELY BEFORE
STARTING THAT STEP.
MANUAL ALL THE WAY
THROUGH BEFORE BEGINNING
TO PUT YOUR POOL TABLE TO-
GETHER! THEN READ EACH
STEP COMPLETELY BEFORE
STARTING THAT STEP.
THE CEMENT USED FOR APPLYING PLAYFIELD CLOTH IS
EXTREMELY FLAMMABLE AND UNDER PRESSURE! CARE-
FULLY READ CAUTIONS ON CEMENT CONTAINER!
KEEP OUT OF REACH OF CHILDREN!
DO NOT USE OR STORE CEMENT NEAR A HEAT SOURCE,
FLAMES, SPARKS OR WHEN SMOKING! WORK AREA MUST BE
WELL VENTILATED. OPEN DOORS AND WINDOWS WHEN
USING CEMENT!
EXTREMELY FLAMMABLE AND UNDER PRESSURE! CARE-
FULLY READ CAUTIONS ON CEMENT CONTAINER!
KEEP OUT OF REACH OF CHILDREN!
DO NOT USE OR STORE CEMENT NEAR A HEAT SOURCE,
FLAMES, SPARKS OR WHEN SMOKING! WORK AREA MUST BE
WELL VENTILATED. OPEN DOORS AND WINDOWS WHEN
USING CEMENT!
This table has been inspected to insure proper fit. Carefully unpack and examine
each shipping container and its packing material before discarding to assure all parts
have been removed. Some smaller parts may be shipped inside larger parts. Check
inside parts before assembling.
each shipping container and its packing material before discarding to assure all parts
have been removed. Some smaller parts may be shipped inside larger parts. Check
inside parts before assembling.
This table is contained in two separate containers:
Container #1. . . . . .
contains three playfield sections.
Container #2. . . . . .
contains beams; long and short slats; top rails; aprons; and playfield cloth, slatron shims,
hardware kits, corner & side caps, corner posts, playfield spots, glue and grout kit
and drop pockets.
hardware kits, corner & side caps, corner posts, playfield spots, glue and grout kit
and drop pockets.
Tools Needed:
+
1/2" Open End Wrench (2)
+
7/16" Open End Wrench (2)
+
3/8" Open End Wrench
+
Phillips Screwdriver
Beside the assembly tools listed above, it would be useful to have a rachet with 1/2, 7/16 and 3/8 sockets and an electric screwdriver.
NOTE: Rails are made with cushion rubber at a height that requires 2 ¼" diameter balls. Your dealer has a complete line of Billiard
Accessories.
Accessories.
NOTE: This table adds weight to any floor. Be sure floor can withstand this kind of weight. If floor sags, table will be impossible to level!
+
Carpenter's Level & 36" Straight Edge
+
Needle Nose Pliers
+
Scissors
+
Putty Knife
+
Hammer (Small Ball Peen Type)
+
Tape Measure
+
Sandpaper (80 grit)
+
Sanding Block
+
Awl or 8d Nail