Escalade Sports 2l-6740-00 Manuel D’Utilisation
Page
3
ASSEMBLE TWO LEG PEDESTALS AS FOLLOWS:
1. Begin by opening hardware kits and sort hardware.
Attach leg panels #20 to leg posts #19 using screws
#29. (Note: Set of screw holes should be closer to the
bottom of the panel when positioned correctly.) Start
by installing the top screws in bottom leg panel using
the pre-drilled starter holes in post #19. Square edge
of leg panel up to edge of post #19 then, install the
bottom two screws #29. Butt top leg panel #20 up to
bottom leg panel and secure in place using screws
#29. (See Figure 1a) Do not tighten screws #29 until
instructed to do so.
Be sure the wood grain faces out away from posts
#19.
#29. (Note: Set of screw holes should be closer to the
bottom of the panel when positioned correctly.) Start
by installing the top screws in bottom leg panel using
the pre-drilled starter holes in post #19. Square edge
of leg panel up to edge of post #19 then, install the
bottom two screws #29. Butt top leg panel #20 up to
bottom leg panel and secure in place using screws
#29. (See Figure 1a) Do not tighten screws #29 until
instructed to do so.
Be sure the wood grain faces out away from posts
#19.
Figure 1c
Figure 1a
Figure 1b
2. Attach inside leg panels #20 to leg posts #19 in same manner
as outside leg panels (See Figure 1b) Do not tighten screws
#29 until instructed to do so. Be sure the wood grain faces
out away from posts #19.
#29 until instructed to do so. Be sure the wood grain faces
out away from posts #19.
3. Attach metal leg facades #21 to pedestals. Attach leg facade
using two screws #30 and two plastic spacers #13. Locate leg
facade #21 by lining up the holes in the facade with the starter
holes in the leg post. See figure 1c.
facade #21 by lining up the holes in the facade with the starter
holes in the leg post. See figure 1c.
4. Set up pedestals so that they face each other.
Figure 2