Troy-Bilt rzt mustang zt50 Manuel D’Utilisation

The drive control levers of the tractor are lowered for shipping 

purposes. The flange lock nuts, hex screws, and flat washers that 

normally secure the control levers in their operating position 

are unfastened and installed in the slotted holes of the control 

levers for shipment. The control levers must be repositioned to 

operate the tractor. To reposition the control levers for operation, 

proceed as follows:

Remove the hex screw, flat washer, and flange lock nut 

1. 

from the slot of one of the drive control levers.
Lift and swing that control lever upward until the slotted 

2. 

hole in the lever bracket aligns with one of the holes in the 

pivot bracket. See Fig. 3-4.

Slide the flat washer onto the hex screw. From the outside, 

3. 

insert the hex screw with washer through the control lever 

slot and the hole of the pivot bracket. Secure with the 

flange lock nut. See Fig. 3-4.
Note the relative position of the control lever to the pivot 

4. 

bracket, then repeat the previous steps to reposition the 

other control lever in approximately the same  position. 
Refer to “Adjusting the Drive Control Levers” in the 

5. 

Maintenance & Adjustments for instructions on the final 

adjustment of the levers.

 

! 

Battery posts, terminals, and related accessories 

contain lead and lead compounds, chemicals known 

to the State of California to cause cancer and 

reproductive harm. Wash hands after handling.

When attaching battery cables, always 

connect the POSITIVE (Red) wire to its terminal first, 

followed by the NEGATIVE (Black) wire.

For shipping reasons, both battery cables on your equipment 

may have been left disconnected from the terminals at the 

factory. To connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The 

negative battery terminal is marked Neg. (–).
NOTE: If the positive battery cable is already attached, skip 

ahead to step 2.

Remove the plastic cover, if present, from the positive 

1. 

battery terminal and attach the red cable to the positive 

battery terminal (+) with the bolt and hex nut. See Fig. 3-5.

Remove the plastic cover, if present, from the negative 

2. 

battery terminal and attach the black cable to the negative 

battery terminal (–) with the bolt and hex nut. See Fig. 3-5.
Position the red rubber boot over the positive battery 

3. 

terminal to help protect it from corrosion.

NOTE: If the battery is put into service after the date shown 

on top/side of battery, charge the battery as instructed in the 

Maintenance section your Operator’s Manual prior to operating 

the tractor.