Troy-Bilt rzt mustang zt50 Manuel D’Utilisation

One Lawn Tractor

• 

One Oil Drain Tube

• 

One Deck Wash Hose Coupler 

• 

One RZT  Tractor Operator’s 

• 

Manual

One Kohler Engine Operator’s 

• 

Manual

Remove the upper crating material from the shipping pallet, and 

cut any bands or tie straps securing the tractor to the pallet. 
Use the lift handle to raise the deck to its highest position. 

Engage the transmission bypass rods on each side of the 

tractor; then carefully roll the tractor off the shipping pallet. 

The transmission bypass rods (one for each the RH and LH 

transmission) are located beneath the frame platform, just inside 

each rear wheel. Disengage the bypass rods.  See Fig. 3-1.

Remove the deck wash system nozzle adapter and oil drain tube 

from the manual bag and store for future use. 

To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan 

attached.

Cut any straps securing the seat assembly and the drive 

1. 

control levers to the tractor. Remove any packing material.

NOTE: Be careful not to cut the wiring harness connecting the 

seat and the seat switch in the bottom of the seat.

Remove the two shoulder bolts and lock nuts in the seat 

2. 

pan as shown in Fig. 3-2.

Rotate the seat into position and secure the seat into place 

3. 

with the previously removed shoulder bolts and lock nuts. 

Be careful not to crimp or damage the wire harness while 

installing the seat. See Fig. 3-3.