Tascam HS-4000 Manuel D’Utilisation

 

 

 
 

When in dual player mode, set which player the controls on the 
front panel affect.   
1.  Press the HOME key on the front panel to open the 

 

   

     

Dual player Home Screen 

SELECT

want to select.   
The background of the selected player becomes yellow.   

   

     

Dual player Home Screen with player B selected 

 
 
 

When a player is selected, press the ONLINE key on the front 
panel to set whether or not the sound from that player is output 
through the output connectors.   
Refer to “Online functions” on page 89 for details about making 
settings for the online outputs. 

You cannot turn this function on or off for a player that is not selected. Select 
the player first and then press the ONLINE key to turn this function on/off for 
it.  

 
 

Press the PLAY key to start playback.   
Press the PAUSE key to pause playback.   
Press the PLAY key again to resume playback.   
Press the STOP (RETAKE) key to stop playback. 
Press the 

. [MARK.] key or / [MARK/] key to 

switch entries. 
Press and hold the 

m [

] or 

, [

] key to search 

backward or forward.   
Press the 

. [MARK.] or / [MARK/] key while 

pressing and holding the SHIFT key to move between marks.   
Press and hold the 

m [

] key or 

, [

] key while 

pressing and holding the SHIFT key to search at high-speed.   

・  On the PLAY SETUP screen, you can set whether only the currently 

・  Playback functions can also be used via parallel control.   

 
 

Press the CALL (CHASE) key to locate to the point where 
playback was last started from playback standby (call point) and 
put the unit in playback standby mode. 
 
 

When the Follow BWF–J item is set to ON, during playback if a 
BWF–J cue point is detected, the following corresponding 
operation will occur. In addition, if the BWF–J Tally Out item is set 
to ON and the unit is in single player mode, in response to each 
BWF–J cue point, the CUE signal and tally signal will be output 

rom the parallel remote connector. 

f

 

BC$STANDBY 

During entry selection, this point is used 
as the playback start point. During 
playback, playback pauses when this 
point is reached. In either case, a 
BC$STANDBY tally is output. 

BC$CM 

During playback, when this point is 
reached, a BC$CM CUE signal is output. 

BC$END 

During playback, when this point is 
reached, a BC$END CUE signal is output. 

BC$STOP 

During playback, when this point is 
reached, a BC$STOP CUE signal is output, 
and playback stops. 

BC$FILE 

During playback, when this point is 
reached, a BC$END CUE signal is output. If 
the beginning of a following take 
(BC$STANDBY CUE point) exists, that CUE 
will be followed. 

BC$PAUSE 

During playback, when this point is 
reached, a BC$PAUSE tally is output, and 
playback pauses. 

 
 

Using a TASCAM RC–HS32PD (sold separately) or other remote 
controller, flash start playback is possible.   
For details, see “Flash start function” on page 90.