Tascam HS-4000 Manuel D’Utilisation

TASCAM HS-4000

10 – Internal settings

CAUTION

・ In both modes, a subfolder is created for each take inside the folder, and

management files are generated in these subfolders.

・ When Session Root mode is selected, the maximum number of takes

that can be recorded in a single session is greatly reduced from normal.
For this reason, when switching to Session Root mode the following
pop-up window appears with a warning about the reduced maximum
limit to the number of takes.

When switching to Sub Folder mode, the following pop-up window
appears explaining the restored maximum limit to the number of takes.

・ When Session Root mode is selected, the number of files created is large.

For this reason, the maximum number of takes that can be recorded is
greatly reduced. (See “Recording operation limitations” on page 30.)

・ During recording, you can press the REC key to start recording a new

take. This function can be used 4 seconds after beginning recording in
polyphonic and subfolder modes, but inSession Root mode, you might
have to wait more than 4 seconds.

Bit Length

Set the quantization bit rate for recording files using the
following buttons.
Setting buttons:

16bit

(default),

24bit

Max File Size

Set the maximum size for recording files using the following
buttons.
Setting buttons:

640MB

1GB

2GB

(default)

Pause Mode

Set whether or not to divide files when a recording is paused
using the following buttons.
Setting buttons:

SPLIT

(default),

NO SPLIT

OPTIONS page

Make settings related to the pre–recording and auto markers.

PreREC Time

When

PreREC Time

, the signal input during recording

standby is captured by the built-in memory for the set amount of
time, allowing a maximum of 5 seconds to be recorded before
recording is started manually.
To set the pre–recording time, touch the knob, and adjust the
value using the DATA dial.
Setting range: 1–5 seconds (default:

seconds)

Auto Marker

Make settings related to auto markers.

Audio Over:

Use this to add markers when the set audio level is
exceeded.
Turn this function ON or OFF and set the detection level.
(Default:

OFF

)

To set the detection level, touch the knob, and adjust the
value using the DATA dial.
Setting options:

–0.20dB

(default),

–0.17dB

–0.13dB

–0.10dB

–0.06dB

–0.03dB

Settings made here are reflected in the

Over

Level

setting

on the

METER SETUP

screen.

Time Interval:

Use this to add marks at fixed time intervals. Turn this
function ON or OFF and set the time interval. (Default:

OFF

)

To set the time, touch the knob, and adjust the value using
the DATA dial. The range of setting values is 1–10 minutes
(default:

minutes).

Sync Unlock:

Use this to add a mark when synchronization with the
master clock is lost. Turn this function ON or OFF. (Default:

OFF

)

NOTE

An “audio over” occurs when the level exceeds the maximum level (full scale)
minus the value set by the user. (In the example above, this would be when
the level exceeds the maximum level minus 0.20 dB.)