Epson powerlite 737c Manuel D’Utilisation

Epson PowerLite 737c Projector

2/05

Epson PowerLite 737c Projector 

- 

13

3. Click the 

Configure

 button. Then click the 

Advanced

 tab 

on the screen that appears. You see a screen like this:

4. Ad hoc mode: Highlight 

Network Type

 in the Property list 

and set the Value to 

802.11 Ad Hoc

.

Access point mode: Highlight 

Network Type

 and set the 

Value to 

Infrastructure

.

5. Ad hoc mode: Highlight 

SSID

 and set the Value to match 

the name you gave the projector’s ESSID (for example, 

CONF ROOM

). 

Access point mode: Highlight 

SSID

 and set the Value to 

match the name assigned to the access point.

6. Highlight 

Encryption

 and make sure it is disabled.

7. Click the 

General

 tab and make sure the network card or 

wireless network device is enabled.

8. Ad hoc mode: Click 

OK

 to close the network card’s 

properties dialog box. Then go to “Projecting Wirelessly” on 
page 15.

Access point mode: On the General tab, select 

Internet

 

Protocol

, then click the 

Properties

 button. You see this 

screen:

9. If your access point uses DHCP, select 

Obtain IP address 

automatically

. Otherwise, select 

Use the following IP 

address

 and enter the required information.

❏

IP address

: Type in the IP address you want to assign 

to the computer. It must be formatted like other 
addresses on the network; usually the first three sections 
(XXX.XXX.XXX) match the access point’s IP address, 
and the last section is unique.

❏

Subnet mask

: For example, 255.255.255.000, but 

this too must match how your network is set up.

❏

Default gateway

: Enter the IP address that was 

assigned to the access point when it was set up.

10.When done, click 

OK

.

11.Click the 

Wireless Networks

 tab. You see this screen:

Configure