Tecumseh snow king oh358sa Manuel D’Utilisation

Page de 32
181-1275-14
4-Cycle • Snow King Engine
Page 13
B. Engines with Recoil Starters
If you have an electric starter see "A. Engines with Electric 
Starters" instructions on page 10. 
DO NOT pull starter rope with 
engine running. Doing so may VOID 
YOUR WARRANTY.
1. To avoid carbon monoxide poisoning, be sure engine is 
outdoors in a well-ventilated area.
2. Be sure fuel valve, if present (see equipment manufac-
turer’s instructions) is open and all switches are on. 
See Figure 25.
3. Move engine speed control to “FAST” position. 
 
4. Set choke control to “FULL CHOKE” position (see 
equipment manufacturer’s instructions). See Figure 24 
on page 12. Afterward, continue reading instructions 
below.
5. Hold the primer bulb in for one full second each time 
you press it. See Figure 28.
• Make sure you cover vent hole with your thumb.
• Repeat twice for a total of three primes. 
 NOTES
DO NOT use primer bulb to restart a warm engine after a 
short shutdown. Doing so will flood the engine and may 
result in equipment malfunction.
If restarting a warm engine after a short shutdown, move 
engine speed control to “FAST” position and move choke 
control to “NO CHOKE” position. See Figures 24, 2
6 and 27 
starting on page 12. Afterward, continue reading 
instructions below.
6. Operate equipment control to release engine brake or 
clutch, if present (see equipment manufacturer’s 
instructions).
!
WARNING
Figure 25. Fuel Valve Positions
Figure 26. Typical Engine Symbols
Figure 27. Engine Speed Control Positions
Figure 28. Pressing Primer Bulb
Fuel Tank
Fuel Valve “OPEN” 
Position Shown
Turn Valve 
Clockwise To 
“OFF” Position
STOP
STOP
SLOW
RUN
FAST CHOKE PRIMER
STOP
1. Engine Speed Control 
2. “STOP” Position
3. “SLOW” Position
4. “RUN” Range
5. “FAST” Position
3
2
1
5
4
1. Primer Bulb
2. Vent Hole
1
2