Philips horizon mcs 130 surround Manuel D’Utilisation
19
Programming radio stations
You can store up to a total of 50 radio stations.
Automatic programming
Press the ® key on the remote control for
about 3 seconds.
about 3 seconds.
SEARCH
is displayed and all
the available stations are programmed
(overriding all former programmed radio
stations).The system will store first the RDS
stations with a strong enough signal, then the
RDS stations with a weaker signal and finally
the non RDS stations.
Note:
- to stop the automatic installation, press the ‡
(overriding all former programmed radio
stations).The system will store first the RDS
stations with a strong enough signal, then the
RDS stations with a weaker signal and finally
the non RDS stations.
Note:
- to stop the automatic installation, press the ‡
key. All stations before the stop, are stored into the
memory.
memory.
Manual programming
&
Briefly press the ® key on the remote control.
The current station number starts flashing and
the station name, in case of a RDS station, or
the tuned frequency is displayed.
The current station number starts flashing and
the station name, in case of a RDS station, or
the tuned frequency is displayed.
é
Hold down the Ò or † key to start the
search for a new radio station.The search will
stop on the next radio station and display the
tuned frequency which will eventually be
replaced by the detected RDS name.
Note: briefly and repeatedly press the Ò or †
key to fine tune the frequency if necessary.
search for a new radio station.The search will
stop on the next radio station and display the
tuned frequency which will eventually be
replaced by the detected RDS name.
Note: briefly and repeatedly press the Ò or †
key to fine tune the frequency if necessary.
é
Use the
P-
or
+
key or the digit keys to select
the station number where you want to store
the new radio station.
the new radio station.
‘
Press the ® key to store the new radio
station on the selected station number.
station on the selected station number.
(
Repeat
&
to
‘
to store another radio
station.
Note: To stop the manually installation, press the ‡
key. Nothing is stored and everything is restored to
the radio status just before entering the manual
installation mode.
key. Nothing is stored and everything is restored to
the radio status just before entering the manual
installation mode.
Give name
&
Select the station number of the radio station
you want to assign a name (for stations without
RDS reception) or to change the name.
you want to assign a name (for stations without
RDS reception) or to change the name.
é
Press and hold the b key on the remote
control for about 3 seconds.The cursor flashes
on the first of 8 characters.
control for about 3 seconds.The cursor flashes
on the first of 8 characters.
“
Press the cursor up/down to change the
character.
character.
‘
Press the
OK
key to confirm the new name.
Note: To erase a station name:
- Select the station number you want to erase the
- Select the station number you want to erase the
name of.
- Press and hold the ‡ key for about 3 seconds.
- the message
- the message
DELETED
appears and the RDS
name or the frequency is displayed.
2229.1 gb 12-03-2003 09:55 Pagina 19