Logitech 900 Manuel D’Utilisation

Page

Turn the remote so that the logic board is face up. 
There are three screws that need to be removed 
so that the front cover can be separated from the 
logic board. Two of the screws are near the bottom 
of the remote on either side and the third screw is 
almost dead-center just above the large silver-col-
ored component cover. These screws are shorter 
than the screws you removed previously so do not 
mix them up.   

 
 
 
 
 
 

Now, the only other thing that needs to be done 
before the logic board can be removed from the 
front cover is to unclip the touch screen ribbon 
cable. Flip the black connecting clamp up and 
back. Do it gently and carefully since it can some-
times detach from the connector and be difficult to 
put back on. Slide the ribbon cable out. 

 
 

To remove the logic board, simply lift it up. It may 
stick a little at the top left where there is a ‘soft’ 
connection (a hole in the board with a mounting 
post through it). Just wiggle it a little and it will 
come free. Now, depending on how you grabbed 
it, only the logic board will come free, or the logic 
board and the plastic button guide template and/or 
the button pads. Either way, all these components 
simply go back together and sit on top of one 
another – no screws, glue, etc. If the plastic button 
guide sticks to the logic board when it comes out, 
or if it stays on top of the button pad, either way 
is fine. Just make sure that if you separate all the 
components that the plastic guide is re-installed in 
the correct way (see reassembly pictures). The but-
ton pads lift right off. 

 
 

.

.

.