bobcat s205 Manuel D’Utilisation
S205 Skid-Steer Loader
Operation & Maintenance Manual
Operation & Maintenance Manual
42
Figure 85
Drive the loader forward until the top edge of the
Bob-Tach is completely under the top flange of the bucket
[Figure 85] (or other attachment).
Bob-Tach is completely under the top flange of the bucket
[Figure 85] (or other attachment).
Figure 86
Tilt the Bob-Tach backward until the cutting edge of the
bucket (or other attachment) is slightly off the ground
[Figure 86].
bucket (or other attachment) is slightly off the ground
[Figure 86].
Push and hold BOB-TACH “WEDGES DOWN” switch
(Front Accessory Panel) (1) [Figure 84] until levers are
fully engaged in the locked position (3) [Figure 84]
(wedges fully extended).
(Front Accessory Panel) (1) [Figure 84] until levers are
fully engaged in the locked position (3) [Figure 84]
(wedges fully extended).
The wedges (4) [Figure 84] must extend through the
holes in the mounting frame of the bucket (or
attachment), securely fastening the bucket to the
Bob-Tach.
holes in the mounting frame of the bucket (or
attachment), securely fastening the bucket to the
Bob-Tach.
WARNING
Bob-Tach wedges must extend through the holes in
attachment. Levers must be fully down and locked.
Failure to secure wedges can allow attachment to
come off and cause injury or death.
attachment. Levers must be fully down and locked.
Failure to secure wedges can allow attachment to
come off and cause injury or death.
W-2102-0588
NOTE: The Power Bob-Tach system has continuous
pressurized hydraulic oil to keep the wedges
in the engaged position and prevent
attachment disengagement. Because the
wedges can slowly lower, the operator may
need to reactivate the switch (WEDGES UP)
before installing an attachment to be sure
both wedges are fully raised before installing
the attachment.
in the engaged position and prevent
attachment disengagement. Because the
wedges can slowly lower, the operator may
need to reactivate the switch (WEDGES UP)
before installing an attachment to be sure
both wedges are fully raised before installing
the attachment.
N-18515
N-18516