Runco crystal cx-70dhd Manuel D’Utilisation

• Do not drop the remote control or expose it to moisture or high temperature.

• The remote control may malfunction under a fluorescent lamp. If that occurs, move the 

plasma display away from the fluorescent lamp.

• Make sure that there is nothing obstructing the infrared beam between the remote 

control and the IR receiver on the plasma display.

• If the effective range of the remote control decreases, or it stops working, replace the 

batteries with new ones.

• Ambient conditions may possibly impede the operation of the remote control. If this 

happens, point the remote control at the plasma display and repeat the operation.

Table 3-1 gives a quick overview of the CX-70DHD installation process. The sections 
following this one provide detailed instructions.

1

Mount the CX-70DHD on a wall or table stand

2

Connect the DHD Controller to the CX-70DHD

3

Connect signal sources to the DHD Controller

4

Connect external controller to DHD Controller RS-232 port 
(optional)

5

Apply power to the CX-70DHD

6

If using the CX-70DHD with a computer, adjust computer 
display properties

7

Display calibration: adjust the following for each input and 
display mode (resolution and frame rate); save settings 
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance