Invacare RPS350-1 Manuel D’Utilisation
SECTION 2—ASSEMBLY
Stand Up Patient Lift
10
Part No. 1078984
SECTION 2—ASSEMBLY
Unpacking the Patient Lift
Unpack the components from the shipping carton.
Assembling the Patient Lift
WARNING
Use only Invacare parts in the assembly of this
patient lift. The base legs, the mast, boom, pump
assembly and swivel bar are manufactured to
specifications that assure correct alignment of all
parts for safe functional operation.
Assembling the Mast Assembly to the Base
NOTE: The mast assembly may be removed from the base for storage
or transporting. The mast assembly MUST be properly secured to the
base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1.
or transporting. The mast assembly MUST be properly secured to the
base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1.
Put the base on the floor.
NOTE: Make sure all four casters make contact with the floor.
2.
2.
Lock both rear casters. Refer to Detail “A”.
3.
Remove the hex bolt, washers and nut that are located in
the U‐shape cut‐out of the base.
the U‐shape cut‐out of the base.
4.
Lift the mast to an upright position.
5.
Lower the mast onto the mounting bracket.
6.
Attach the mast to the base with the hex bolt, washers and
nut. Tighten securely.
nut. Tighten securely.
Prepare Lift for Use
Check and tighten all hardware BEFORE use.
Install the Shifter Handle
NOTE: For this procedure, refer to FIGURE 2.2.
1.
1.
Remove the shifter handle from the packaging carton.
2.
Thread the shifter handle onto the male adapter on the
base.
base.
FIGURE 2.1 Assembling the Mast Assembly to the Base
Step Here
to Lock
Step Here
to Unlock
Nut
Washer
Hex Bolt
Mounting Bracket
Locking
Lever
LOCKED
UNLOCKED
DETAIL “A”
Washer
Shifter Handle
Male Adapter
in Base