Q-Logic 8200 Manuel D’Utilisation
2–Configuring NIC
NIC TroubleShooting/Diagnostics
NIC TroubleShooting/Diagnostics
2-46
SN0054671-00 A
# ethtool -t eth4
The test result is PASS
The test extra info:
Register_Test_on_offline 0
Link_Test_on_offline 0
Interrupt_Test_offline 0
Loopback_Test_offline 0
The test result is PASS
The test extra info:
Register_Test_on_offline 0
Link_Test_on_offline 0
Interrupt_Test_offline 0
Loopback_Test_offline 0
Linux Diagnostic Test Descriptions
Internal Loopback Test performs internal packet loopback.
Flash Test verifies the Flash read and write.
Hardware Test verifies that the hardware is running.
Interrupt Test enables and disables the interrupt and functional verification
tests.
tests.
Link Test verifies that the port is linked, meaning that the port has a good
cable attached to the port and that other end of the cable is connected to an
operational Ethernet port, either another NIC port or a network device, such
as a switch.
cable attached to the port and that other end of the cable is connected to an
operational Ethernet port, either another NIC port or a network device, such
as a switch.
Register Test verifies the NIC register read and write.
Linux Diagnostic Test Messages
Test information and PASS or FAIL messages are displayed for each of the tests
listed in
listed in
Windows Property Page Diagnostics
This section covers the following information for user diagnostics for Windows NIC
driver management applications:
driver management applications:
Running Windows User Diagnostics
You can run user diagnostics using either the QConvergeConsole GUI or the CLI.
NOTE:
The current release does not support external and internal loopback tests.
Support is expected in a future release.
Support is expected in a future release.