Q-Logic 8200 Manuel D’Utilisation
2–Configuring NIC
NIC TroubleShooting/Diagnostics
SN0054671-00 B
2-81
You can run additional diagnostics in the CLI as listed in the following table. To
determine the
determine the
cna_port_inst
, issue the
qaucli -nic –i
command as shown
Windows Diagnostic Test Descriptions
This section provides descriptions of the following Windows diagnostic tests:
Table 2-15. Running Windows Diagnostic Tests in the CLI
Test Type
Command
External Loopback
qaucli -nic -extloopback <cna_port_inst>
<tests_num> <on_error>
Where <tests_num> specifies the number of tests,
<tests_num> <on_error>
Where <tests_num> specifies the number of tests,
1–65535, and <on_error> is either 0=Ignore or 1=Abort.
NOTE: This test requires a pass-through module to be con-
figured for both ports. Test runs between two ports. Single
port loopback is not supported.
NOTE: This test requires a pass-through module to be con-
figured for both ports. Test runs between two ports. Single
port loopback is not supported.
Flash
qaucli –nic –testflash [cna_port_inst]
Hardware
qaucli –nic –testhw [cna_port_inst]
Internal Loopback
qaucli -nic -intloopback <cna_port_inst>
<tests_num> <on_error>
Where <tests_num> specifies the number of tests,
<tests_num> <on_error>
Where <tests_num> specifies the number of tests,
1–65535, and <on_error> is either 0=Ignore or 1=Abort
Interrupt
qaucli –nic –testinterrupt [cna_port_inst]
Link
qaucli -nic -testlink [cna_port_inst]
Ping (IPv4)
qaucli -nic -ping <cna_port_inst>
<hostname_or_IPv4> [<count> <pocket_size>
<timeout_ms> <TTL>]
Where the default values are count=5,
pocket_size=525, timeout_ms=1000, and TTL=30
<hostname_or_IPv4> [<count> <pocket_size>
<timeout_ms> <TTL>]
Where the default values are count=5,
pocket_size=525, timeout_ms=1000, and TTL=30
Register
qaucli -nic -testregister [cna_port_inst]
Transceiver DMI Data
qaucli -nic -trans [cna_port_inst]