Konica Minolta kn-304 Manuel D’Utilisation

Chapter 7  Troubleshooting

KN-304 Network Board 7-7

●

Troubleshooting Network Hardware Connections

• For 100BaseT or 10BaseT, check that the network connector is plugged into the RJ connector on the

KN-304.

• Try another cable to make sure you do not have a bad cable.

●

Troubleshooting NetWare Protocol

It is recommended you use MAP to get the NetWare setup and parameter values.  If you have not resolved

the problem after running MAP, go through the checklists in this section.

●

NetWare Checklist

• Is the print server name entered correctly?  The factor-default name is KON_serial number. The

serial number is located on the card.

• Did you assign print queues to the printer?  It is recommended you assign each print queue to only

one Print Server Card-connected printer.  If print queues are assigned to other network printers, the

print jobs may be going to an other network printer.

• Did you assign the printer to the type Remote Other /Unknown?

• If the PCONSOLE settings are correct, the connection between the printer and network may have

been broken.  Turn the printer off and, using PCONSOLE, wait for the status message Not Con-

nected.  Turn the printer on and the status should change to Waiting for Job.