Konica Minolta kn-304 Manuel D’Utilisation

Chapter 7  Troubleshooting

KN-304 Network Board 7-9

also change the name in PCONSOLE before you can print.

• Use PCONSOLE to check the Printer Status.  Make sure it is not stopped or paused.

• You cannot use PCONSOLE Version 1.0 to configure the network interface card.  Connect Novell for an

upgrade.

●

Printer Server/File Server/Printer Checklist

Check the following to see if:

• The KN-304 Print Server can log into the file server, and can service jobs from a File Server.

• The KN-304 Print Server name is listed on that File Server.

• The password assigned to the Print Server Card through PCONSOLE matches the password assigned

through MAP.  Use MAP to update the password stored in the network Print Server’s memory.

• The print job is in the print queue and waiting to be printed.  Use PCONSOLE to check if the print jobs

are being sent to the printer.

●

Workstation to Print Server Card Connection Checklist

To make sure the workstation is communicating with the Print Server Card, check the following:

• Print a file from the workstation and make sure the print job gets to the print queue using PCONSOLE.

If the print job does get to the queue, the problem is not with the workstation/print server connection.

• Use CAPTURE to send data to the printer from a workstation software application.  See your NetWare

print server manual for information.

• Make sure another printer is not taking the print jobs from the queues BEFORE the Print Server Card

can service the job.  To do this, disable the other printer until you can verify the Print Server Card-

connected printer setup.

●

KN-304 Loses Its File Server Connection

If the KN-304 loses its connection to the file server, it can take approximately 5 to 10 minutes to reconnect.

If the connection is not made after a reasonable amount of time, check the error conditions to troubleshoot

the problem.