Nilfisk scrubtec 586 Manuel D’Utilisation

SCRUBTEC R Manual Steering

3

/

16

” 

minimum

A

B

  

Level Indicators for the Charge of the Batteries
The battery meter ( see fi gure 7) on the control panel has a digital read out 
with 10 fi xed positions (A) and also a blinking indicator (B).  The bars that 
appear on the display show the approximate charge level with icon (blinking) 
discharged battery.

NOTE: A few seconds after the voltage reads 32V it will start blinking.  The 
brush motors will then automatically switch off.

To install the squeegee onto the machine, follow this procedure:

1.  The squeegee assembly has a break away feature that is also used 

for mounting the squeegee. Loosen the knobs on the squeegee 
(fi gure 8).  Slide the stud  into the slotted hole in the support frame on 
the machine.  

2.  Attach the vacuum hose cuff to the squeegee hose fi tting (see fi gure 

9).

3.  Tighten knobs.  NOTE: Do not overtighten or break away feature 

NOTE: To prevent damage to the squeegee or machine, the squeegee was 
designed to break away from the machine.  If the squeegee is impacted and 
it breaks away from the machine, simply reinstall it by following step 1-3.

During operation, the rear squeegee blade should have a constant 3/16” 
minimum fl are along the entire squeegee blade (see fi gure 10).

1.  The squeegee body can be tilted to adjust the squeegee blade fl are 

in the middle to match the fl are on the ends.  To adjust the tilt, loosen 
the adjusting bolt located on the left and right side of the squeegee 
(see fi gure 9).

2.  Press down on the squeegee until both sets of guide wheels contact 

fl oor.

3.  After making adjustments, retighten the screw(s).

NOTE: It is important that the right and left wheels are contacting the fl oor in 
order for the squeegee to work.

NOTE: As the rear squeegee blade wears, it can be rotated and/or fl ipped to 
obtain four good edges before having to change blades.