Nilfisk scrubtec 586 Manuel D’Utilisation

   Operator’s Manual - SCRUBTEC R Manual Steering

  

How to Return One Touch to Factory Default Settings
To restore the factory settings, follow the procedures below:

  1.  Press and hold the green one touch button (fi gure 17) until you hear 

a double beep from the machine.  NOTE:  The time required for 
this will be approximately 15 seconds. 

  2.  The settings should be returned to 2 bars of solution and 1 bar of 

brush pressure.  NOTE:  The squeegee vac switch must be in the 
middle position for default settings to work. 

  1.  Engage manual override on brake (see page 9, “Parking Brake”).
 
  2.  Remove foot plate and 4 screws and locate steering motor.

  3.  Using the knob on steering motor,  turn shaft on motor  in direction 

you wish to turn machine.

  4.  Slowly push machine to desired location.  NOTE: If you attempt to 

  5.  After moving machine, disengage manual brake override.  NOTE: 

Seat Adjustment (Standard)
The standard seat is not adjustable forward or backward.

Seat Adjustment (Deluxe)
The optional deluxe seat is adjustable in three ways:

  1.  The seat can be adjusted to the forward/backward position by using 

the lever on the lower right side of the seat .  Moving the lever will 
allow the seat to slide into the preferred position.  See fi gure 19.

  2.  To adjust the angle of the back support portion of the seat, turn the 

lever located in the middle right position of the seat.  Turning this 
clockwise will make the seat more vertical.  Turning the knob coun-
terclockwise will tilt the seat back.  

  

See fi gure 20 A.

  3.  To adjust the suspension of the seat  for operator comfort, use the 

lever on the side of the back support section of the seat.  This has 
three positions.  The upper position is for light weight operators. The 
middle position is for medium weight operators.  The bottom position 
is for heavy weight operators.  See fi gure 20, B.  NOTE: The lever 
must be pressed fi rmly to change positions.