NEC PD754244 Manuel D’Utilisation
CHAPTER 6 PERIPHERAL HARDWARE FUNCTION
173
User’s Manual U10676EJ3V0UM
6.4.6 Notes on using timer counter
(1) Error when timer starts
After the timer has been started (bit 3 of TMn has been set to “1”), the time required for generation of the match
signal, which is calculated by the expression (contents of modulo register + 1)
× resolution, deviates by up
to one clock of the count pulse (CP). This is because timer counter count register Tn is cleared asynchronously
to CP, as shown below.
1
2
3
1
2
Timer starts
Timer starts
Count pulse (CP)
Timer counter count
register (Tn)
0
0
If the frequency of CP is greater than one machine cycle, the time required for generation of the match signal,
which is calculated by the expression (modulo register contents + 1)
× resolution, deviates by up to CP2 clock
after the timer has been started (bit 3 of TMn has been set to “1”). This is because Tn is cleared asynchronously
to CP, based on to CPU clock, as shown below.
1
1
2
Timer starts
Timer starts
Count pulse (CP)
Timer counter count
register (Tn)
0
0
Remark n = 0 to 2