Zalman fc-zv9 Manuel D’Utilisation

① Insert the Rubber Rings into the VGA cooler’s Nipple. 

② Install the Nipple-attached VGA cooler on the VGA card’s Mounting Holes. 

※ The VGA Chipset MUST be positioned on the center of the VGA Cooler’s base. 

③ Simultaneously hold the VGA Cooler and the VGA card with one hand, then flip the VGA card

so that its rear-side is facing upwards. 

(Note)
Make sure that the VGA Chipset and the VGA Cooler’s base do not get disconnected while simultaneously
flipping the VGA Cooler and the VGA card. 

Slowly turn the Spring in counter-clockwise motion so 

that the Spring is correctly attached to the Fixing Nut. 

Note 1) 
The ends of the Springs are of different diameters. Install
the Spring end with the shorter diameter on the Fixing Nut. 

Make sure that the Spring is installed perpendicularly and

not leaning to one side. 

VGA Cooler

Nipple

Rubber Ring

Nipple

Rubber Ring

Mounting Hole

VGA Chipset

Nipple

VGA Cooler

Spring

Fixing
Nut

※

The specifications of any product may change without prior notice to improve performance.

4