Zalman fc-zv9 Manuel D’Utilisation
6. Fixing Nut Installation on the Nipples
① Place a PVC Washer over each Nipple.
② Slightly screw each of the four Spring-attached-Fixing Nuts onto each Nipple, then tighten
each Fixing Nut one rotation at a time until all are completely tightened.
8. Fan Power Cable Connection (FAN MATE 2 connection)
7. VGA Card Installation
Insert the assembled VGA card into the motherboard’s
PCIe (or AGP) slot. Use the Fixing Bolt to secure the
PCIe (or AGP) slot. Use the Fixing Bolt to secure the
VGA card onto the computer case. If the VGA card
has a power connector on it, remember to plug in the
power cable.
Note 1)
Fully tightening one Fixing Nut at a time may result
in damaging the VGA chipset. Please tighten each
Fixing Nut one rotation at a time until all are
completely tightened.
Fully tightening one Fixing Nut at a time may result
in damaging the VGA chipset. Please tighten each
Fixing Nut one rotation at a time until all are
completely tightened.
Note 2)
Make sure that the VGA Cooler’s base and the
VGA Chipset are completely in contact with each
other.
Make sure that the VGA Cooler’s base and the
VGA Chipset are completely in contact with each
other.
Note 3)
Make sure that the VGA Cooler does not interfere
with the VGA card's capacitors and other components.
Make sure that the VGA Cooler does not interfere
with the VGA card's capacitors and other components.
PCIe
Slot
Slot
Fixing
Bolt
Bolt
Nipple
Fixing Nut
PVC Washer
VGA Cooler
①
① Installing FAN MATE 2 on the Inside of the System ②
② Installing FAN MATE 2 on the Outside of the System
Connect the appropriate 3-pin connectors on the
cable to the motherboard’s Fan Header and the
FC-ZV9 Fan Connector.
cable to the motherboard’s Fan Header and the
FC-ZV9 Fan Connector.
Pull the 6-pin Connector out of the system
through the back and connect it to FAN MATE 2,
which should be installed on the case using the
included Double-Sided Tape (
through the back and connect it to FAN MATE 2,
which should be installed on the case using the
included Double-Sided Tape (
⑪).
◆ When the RPM Control Knob on FAN MATE 2 is turned fully counter-clockwise, the fan operates in
Quiet Mode. Turned fully clockwise, it operates in Normal Mode. You can select the desired fan RPM
by turning the knob.
※
※ Performance can be increased by adjusting the RPM control knob of the FAN MATE 2.
Note) FAN MATE 2 has been specifically designed for the fan of this product.
Zalman Tech Co., Ltd. is not responsible for any damage to systems or VGA Chipsets caused by
using it with other types of fans.
RPM Control Knob
Fan Connector
(FC-ZV9)
Motherboard
Double - Sided Tape
FAN MATE 2
6-Pin Connector
※
The specifications of any product may change without prior notice to improve performance.
5