Crestron b-g2-fp b-g3-fp Manuel D’Utilisation

2 and 3 Gang Faceplates

 

Crestron B-G2-FP & B-G3-FP

1.  Turn Cresnet system power OFF. 
2.  Connect the Cresnet cable to the keypads’ Cresnet ports and 

the other ends to the control system. 

3.  Attach the two keypad button assemblies to the detent plate 

using the (4) 3/16 in. flathead screws (supplied with keypads).  

CAUTION:  Excess wire that is pinched between the keypad and 
electrical box could short out. Make sure that all excess wire is 
completely inside the electrical box and not between the box and the 
keypad. 

4.  Make sure 2-gang unit is oriented as marked with keypads’ 

arrows at top, and place unit in the electrical box. 

5.  Attach units using the (4) 1 in. panhead screws (supplied with 

keypads). 

6.  Attach buttons with LED window oriented upward to match 

each LED indicator. 

7.  Attach dividers making sure dividers’ interlock tabs are 

oriented correctly (refer to the “Interlock Tabs Example” 
illustration on page 8).  

8.  Attach faceplate (orient with arrow up, make sure it snaps into 

place). 

NOTE:  If you are installing a metal 2-gang faceplate, carefully clean 
plastic faceplate mentioned in step 8, (leave no dust or debris on 
faceplate), observe alignment, remove adhesive liners from inner surface 
of metal faceplate and mount over 2-gang plastic faceplate. 

9.  Turn Cresnet system power ON. 

•  2 and 3 Gang Faceplates:  B-G2-FP & B-G3-FP