Crestron b-g2-fp b-g3-fp Manuel D’Utilisation
Crestron B-G2-FP & B-G3-FP
2 and 3 Gang Faceplates
NOTE: All Cresnet wiring must consist of two twisted-pairs. One
twisted pair is the +24V conductor and the GND conductor and the other
twisted pair is the Y conductor and the Z conductor.
twisted pair is the +24V conductor and the GND conductor and the other
twisted pair is the Y conductor and the Z conductor.
NOTE: When daisy-chaining Cresnet units, strip the ends of the wires
carefully to avoid nicking the conductors. Twist together the ends of the
wires that share a pin on the network connector, and tin the twisted
connection. Apply solder only to the ends of the twisted wires. Avoid
tinning too far up the wires or the end becomes brittle. Insert the tinned
connection into the Cresnet connector and tighten the retaining screw.
Repeat the procedure for the other three conductors.
carefully to avoid nicking the conductors. Twist together the ends of the
wires that share a pin on the network connector, and tin the twisted
connection. Apply solder only to the ends of the twisted wires. Avoid
tinning too far up the wires or the end becomes brittle. Insert the tinned
connection into the Cresnet connector and tighten the retaining screw.
Repeat the procedure for the other three conductors.
Identity Code
Every equipment and user interface within the network requires a unique
identity code (NET ID). Refer to latest version of the Operations and
Installation Guide for the Single Gang Keypads, Doc. 8173, for
procedures on setting the NET ID.
identity code (NET ID). Refer to latest version of the Operations and
Installation Guide for the Single Gang Keypads, Doc. 8173, for
procedures on setting the NET ID.
Installation
NOTE: For simplicity, the following procedure is for a 2-gang unit.
Tools/hardware required
2-gang Plastic Faceplate (supplied with B-G2-FP)
2-gang Detent Plate (supplied with B-G2-FP)
(2) Single Gang Keypads (supplied separately), which includes:
Buttons
(2)
2-gang Detent Plate (supplied with B-G2-FP)
(2) Single Gang Keypads (supplied separately), which includes:
Buttons
(2)
Dividers
(4) 1 in. panhead phillips screws
(4) 3/16 in. flathead phillips screws
Cresnet network cable (supplied separately)
Phillips screwdriver (supplied by other)
Phillips screwdriver (supplied by other)
After the Cresnet network wiring has been installed and verified, use the
following procedure to install the keypads in a standard, 2-gang electrical
box (refer to illustrations on pages 7 and 8).
following procedure to install the keypads in a standard, 2-gang electrical
box (refer to illustrations on pages 7 and 8).
Installation Guide - DOC. 8182
2 and 3 Gang Faceplates: B-G2-FP & B-G3-FP
• 5