Zebra 49834 Manuel D’Utilisation
222
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Preventive and Corrective Maintenance
Drive System—Stepper Motor Pulley
5.
. What model print engine do you have?
6.
. Tighten the four stepper motor pivot screws.
7.
. Reconnect the stepper motor power connector to the DC power supply.
8.
. Reinstall the electronics enclosure framework.
9.
. Reinstall the diagonal brace.
10.
. Carefully slide the PCB access panel partially into the print engine.
11.
. Reattach all connectors previously removed.
12.
. Slide the PCB access panel the rest of the way into the print engine and
reinstall the nine mounting screws to secure it.
13.
Refer to
to close the print engine, reinstall it into the applicator,
and to resume printer operation.
If you have a...
Then...
Right-hand print engine
As seen from the rear, slide the stepper motor to the right to
adjust the tension on the stepper motor belt.
adjust the tension on the stepper motor belt.
Left-hand print engine
As seen from the rear, slide the stepper motor to the left to
adjust the tension on the stepper motor belt.
adjust the tension on the stepper motor belt.
Caution • Be sure the connector leads are tucked in and are not pinched.