Runco pl-61dhd Manuel D’Utilisation
Runco PlasmaWall Owner’s Operating Manual
21
PRE
L
IMINAR
Y
Digital Video Connection: The PlasmaWall has a DVI input, labeled PC3. Connect the
DVI output from the DHD Controller to this input, using a standard DVI cable.
DVI output from the DHD Controller to this input, using a standard DVI cable.
RGB-HD Connection: Connect the RGBHV output from the DHD Controller to the
PC2/COMPONENT2 input on the PlasmaWall. Use a standard RGBHV breakout cable
with 5 BNC connectors at each end.
PC2/COMPONENT2 input on the PlasmaWall. Use a standard RGBHV breakout cable
with 5 BNC connectors at each end.
RS-232 (External Control) Connection: Connect the RS-232 output from the DHD
Controller to the RS-232C input on the PlasmaWall. Use a standard, modular telephone
cable with RJ11 plugs at both ends. On the PlasmaWall end, use the provided
RJ11-to-DB9, crossover adapter. This adapter is wired as shown in Figure 3-4.
Controller to the RS-232C input on the PlasmaWall. Use a standard, modular telephone
cable with RJ11 plugs at both ends. On the PlasmaWall end, use the provided
RJ11-to-DB9, crossover adapter. This adapter is wired as shown in Figure 3-4.
Figure 3-4. RS-232 Connection from the DHD Controller to the PlasmaWall
3
4
2, 5
XMT DATA
RCV DATA
REQUEST TO SEND
SIG GND
2
3
7
8
5
RCV DATA
XMT DATA
CLEAR TO SEND
NO CONNECTION
1, 6
1, 9
4
6
SIG GND
DATA SET READY
DATA TERMINAL READY
To/From
DHD
Controller
RJ-11 Male
DB-9 Female
1
5
6
9
RS-232C