eutech-instruments cyberscan con 11 conductivitytds meter Manuel D’Utilisation
Instruction Manual
CON 11/110
28
7
PRINT FUNCTION (FOR CON 110 ONLY)
The CON 110 meter is equipped with an RS232 communication port and a PRINT
(
(
) key that facilitate the printing of data from the meter to a printer or computer.
7.1
Using CON 110 Meter with Printer or Computer
1. To use the CON 110 directly with a printer, the printer should have either
a 9 pin or a 25 pin RS 232C serial port.
2. Communication settings of the printer or computer’s data acquisition
software (CyberComm Portable DAS) MUST match the following
parameters:
parameters:
a. Baud Rate:
9600
b. Parity Bit:
None
c. Stop Bit:
One
d. Data Bit:
8
e. Flow Control: None
Please refer to your printer’s or computer’s instruction manual for more information
on its communication setup protocol.
on its communication setup protocol.
3. Use 9-pin cable (Refer to section –List OF Accessories on page 68) to
connect the meter to the printer. If the printer has a 25 pin connector, use
the 9 to 25 pin cable or make your own cable taking note of the
connection parameters as described in section 3.6- Connecting the
RS232C Cable (Only for CON 110) on page 9.
the 9 to 25 pin cable or make your own cable taking note of the
connection parameters as described in section 3.6- Connecting the
RS232C Cable (Only for CON 110) on page 9.
4. Turn on CON 110 meter and note the following:
a. For printer, ensure it is powered on and paper is loaded.
b. For computer, ensure that Eutech Instruments’ CyberComm
b. For computer, ensure that Eutech Instruments’ CyberComm
Portable Data Acquisition Software is installed and activated. See
section 9.3- Running CyberComm Portable on page 59.
section 9.3- Running CyberComm Portable on page 59.
5. To send data to the printer or computer, press the PRINT (
) key.