Kofax vrs4 Manuel D’Utilisation
Chapter 3
82
VRS User’s Manual
Note
Auto-Orientation may conflict with the rotation options that are available with
some scanners that support advanced features. If you are using VRS with such a
scanner, we recommend that you enable either Auto Orientation or the advanced
rotation options, but not both. For more information, refer to Rotation Tab on page 105.
X To change the Skew panel settings
1
From the VRS Adjustment Controls, select the Skew panel.
2
Select the desired Deskew and Crop options.
3
If automatic deskew is not selected, you can use the movable angle control
arm to straighten an image by clicking anywhere on the grid. You can also
adjust the skew as follows:
a
Position the mouse over the vertical arm, click, and hold. The cursor will
change to a hand.
b
Drag the arm counter-clockwise to rotate the image to the left, or
clockwise to rotate it to the right. You can rotate the image up to 360
degrees.
4
If desired, use the Fine Angle Adjustment slider to fine-tune the deskew angle
in single degree or partial degree increments, as follows:
a
Move the slider all the way to the left to complete a one-degree, counter-
clockwise angle adjustment.
b
Move the slider all the way to the right, to complete a one-degree,
clockwise angle adjustment.
c
Move the slider to a position in between the leftmost or rightmost setting,
to select an angle shift that is less than a full degree. Each line on the slider
scale represents 0.05 degrees.
scale represents 0.05 degrees.
5
Click OK.
Note
Changes made to the Skew panel are handled according to
circumstances under which the VRS Interactive Viewer launched. If the
viewer opened as the result of an exception, any changes apply to the
exception image only. If the viewer opened because you selected Preview or
First Page mode, the changes apply to the exception image as well as to
subsequent scans. Upon restart, the Skew panel is always reset to the last
selected profile’s settings.