Kofax vrs4 사용자 설명서

Chapter 3

VRS User’s Manual

Auto-Orientation may conflict with the rotation options that are available with 

some scanners that support advanced features. If you are using VRS with such a 

scanner, we recommend that you enable either Auto Orientation or the advanced 

rotation options, but not both. For more information, refer to Rotation Tab on page 105.

X To change the Skew panel settings

From the VRS Adjustment Controls, select the Skew panel.

Select the desired Deskew and Crop options.

If automatic deskew is not selected, you can use the movable angle control 

arm to straighten an image by clicking anywhere on the grid. You can also 

adjust the skew as follows:

Position the mouse over the vertical arm, click, and hold. The cursor will 

change to a hand. 

Drag the arm counter-clockwise to rotate the image to the left, or 

clockwise to rotate it to the right. You can rotate the image up to 360 

degrees.

If desired, use the Fine Angle Adjustment slider to fine-tune the deskew angle 

in single degree or partial degree increments, as follows:

Move the slider all the way to the left to complete a one-degree, counter-

clockwise angle adjustment.

Move the slider all the way to the right, to complete a one-degree, 

clockwise angle adjustment. 

Move the slider to a position in between the leftmost or rightmost setting, 

to select an angle shift that is less than a full degree. Each line on the slider 
scale represents 0.05 degrees.

Click OK.

Changes made to the Skew panel are handled according to 

circumstances under which the VRS Interactive Viewer launched. If the 

viewer opened as the result of an exception, any changes apply to the 

exception image only. If the viewer opened because you selected Preview or 

First Page mode, the changes apply to the exception image as well as to 

subsequent scans. Upon restart, the Skew panel is always reset to the last 

selected profile’s settings.