Pentax Q10 Mode D’Emploi
188
Cha
ng
ng
in
g Add
itio
itio
na
l Settin
gs
8
4
Press the 4 button.
5
Press the 3 button.
The screen that was displayed before selecting the menu appears again.
Pixel Mapping is a function for mapping out and correcting defective pixels
in the CMOS sensor.
Attach a 01 STANDARD PRIME or 02 STANDARD ZOOM lens
to the camera.
1
Select [Pixel Mapping] in the [R Set-up 3] menu, and press
the four-way controller (5).
The [Pixel Mapping] screen appears.
2
Press the four-way controller (2) to select [Pixel Mapping],
and press the 4 button.
Defective pixels are mapped out and corrected, and the screen that was
displayed before selecting the menu appears again.
Correcting Defective Pixels in the CMOS Sensor
(Pixel Mapping)
• It takes about 30 seconds to correct the defective pixels.
• When the battery level is low, [Not enough battery power remaining
• When the battery level is low, [Not enough battery power remaining
to activate Pixel Mapping] is displayed on the monitor. Use the AC adapter
kit (optional) or install a fully charged battery.
e_kb535_ENG.book Page 188 Wednesday, October 10, 2012 3:03 PM