Panasonic KXTCD200G Mode D’Emploi
Preparation
8
Battery installation
1
Insert the batteries negative (T) terminal
first.
first.
2
Close the handset cover.
Hinweis:
L
L
Use only rechargeable batteries (Seite 4).
Battery charge
Place the handset on the base unit for about 7
hours before initial use.
When charging, the battery icon is shown as
follows.
hours before initial use.
When charging, the battery icon is shown as
follows.
When the batteries are fully charged, 5
remains on the display.
remains on the display.
Hinweis:
L
L
It is normal for the handset to feel warm during
charging.
charging.
L
It takes 7 hours to fully charge the batteries,
however, you can use the handset before the
batteries are fully charged.
however, you can use the handset before the
batteries are fully charged.
L
Clean the charge contacts (Seite 6) of the
handset and base unit with a soft, dry cloth
once a month, otherwise the batteries may not
charge properly. Clean more often if the unit is
exposed to grease, dust or high humidity.
handset and base unit with a soft, dry cloth
once a month, otherwise the batteries may not
charge properly. Clean more often if the unit is
exposed to grease, dust or high humidity.
Battery strength
Hinweis:
L
L
When 7 flashes, recharge the handset
batteries. 7 will continue to flash until the
batteries have been charged for at least 15
minutes.
batteries. 7 will continue to flash until the
batteries have been charged for at least 15
minutes.
L
If the handset is turned off, it will be turned on
automatically when it is placed on the base
unit.
automatically when it is placed on the base
unit.
Battery icon
Battery strength
5
High
6
Medium
7
Low
When flashing: Needs to
be charged.
When flashing: Needs to
be charged.
TCD200G(e-g).book Page 8 Tuesday, February 8, 2005 8:57 AM